Motor Mount, front right & left.

• Eldorado

PART #05-008X
$40.00 / pair

Motor Mount, front right & left.

• All models except : Eldorado

PART #05-007X
$60.00 /pair

Transmission Mount. Replaces original GM part # 3633087 .

• All models except : Eldorado

PART #05-005X
$25.00 ea.

Plug, Brake Adjustment Hole. Replaces original GM part #5467299. 1-1/4 Overall length X 7/8" tall, fits 5/16" X 1" slot.

• Models w/ drum brakes

PART #08-001X
$1.40 ea.

Click to ENLARGE

Cover, Battery Clamp. Control unsightly sulphate build-up & help protect the nearby metal and finish. Available in black or red, sold separate.

PART #06-007X (black)
$8.00 ea.

PART #06-013X (red)
$8.00 ea.

Click to ENLARGE

Motor, Window Lift. Used for front or rear door window & rear quarter window. Factory rebuilt GM part# 5045639 & 5045640. ***Please note: motors are in stock, however this is an exchange item only - there will be a refundable core charge.***

• All models

PART #06-123X (driver side)
$74.50 ea.

PART #06-124X (passenger side)
$74.50 ea.

REFUNDABLE CORE CHARGE $25.00/motor

Pad, Headlight Dimmer Switch. Rubber slip-over cover for floor mounted switch.

• All models

PART #06-002P
$5.60 ea.

Propeller Shaft Bearing Retainer. Replaces original GM part #7802241. Fits Series 75 and Commercial Chassis (Hearse. Ambulance, etc.) Re-vulcanization service only. Send in your old re-buildable retainer. Please allow 4 weeks for service.

• Series 75 & Commercial Chassis

PART #09-003U
$180.10 ea.

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

A: Control Arm Shaft & Bushings, front upper, driver or passenger side, 2 kits required per car. Available with or without shaft.

B: Control Arm (Rebound) Bumper - NOT AVAILABLE

C: Ball Joint, front upper.

D: Camber Eccentric, passenger or driver side, 2 required per car.

E: Spring Insulator Cushion - NOT AVAILABLE

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

F: Control Arm Bushings, front lower, driver or passenger side, 2 required per car.

G: Shock Bushing - NOT AVAILABLE

H: Lower Arm Bumper - NOT AVAILABLE

I: Ball Joint, front lower, driver or passenger side, 2 required per car.

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

K: Stabilizer End Kit, 22 piece, 1 kit required per car.

L: Stabilizer/Sway Bar to Frame Bushing, 1 pair required per car.

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

J: Strut Rod Bushing Kit, 1 kit required per car.

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

M: Center Link

N: Outer Tie Rod End, passenger or driver side, 2 required per car.

O: Inner Tie Rod End, passenger or driver side, 2 required per car.

P: Tie Rod Sleeve, passenger or driver side, 2 required per car.

**DIAGRAM ABOVE IS FOR ILLUSTRATION ONLY. ACTUAL PARTS FOR YOUR VEHICLE MAY LOOK DIFFERENT.**

Q: Spring Shackle Bushings - NOT AVAILABLE

R: Rubber Bumper - NOT AVAILABLE

S: Rear Spring Insulator, upper or lower, 4 required per car

Bumper, Front Hood Adjuster, 2 3/8" tall with 1-1/8" diameter head. Replaces original GM part # 400765.

• Some models as required

PART #04-104B
$5.40 ea.

Click to ENLARGE

Bumper Cap, Front Hood Adjuster. Slips over the adjustable bolt for the hood.  Nice reproductions.  Caps are approx. 1-1/16" diameter, 11/16" tall.  Will slip over 1/2" to 7/8" head.

• All models

PART #04-140B
$3.40 ea.

Clip, Hood to Cowl Weatherstrip. Replaces original GM part #480534. Normal usage is 14 to 16 per car as needed. 3/4" Tall with a 1" wide head.

• All models

PART #04-101F
$0.60 ea.

Hood to Cowl Seal. Correct rubber extrusion replacement for original GM part #9886375, #9873794, or #1498724.

• All models

PART #04-113C
$24.80 ea.

Splash Apron Set. Die cut from original style masticated rubber for a factory fit. Pieces fit over a-arm, and inside inner fenders. 4 piece kit.

• All models except : Eldorado & Seville

PART #03-111M
$65.00 / kit

Splash Apron Set. Die cut from original style masticated rubber for a factory fit. Pieces fit over a-arms, and inside inner fenders. 6 piece kit.

• Eldorado only

PART #03-110M
$49.99 / kit

Rear Quarter Window Leading Edge Seal. These weatherstrip's will have a metal core if required for proper operation.

Beltline / Window Felt Weatherstrip Kit. Front doors only, inner and outer. Kit can also be cut to fit rear quarter area.

• Eldorado hardtop

PART #10-040X
$97.50 / kit

Beltline / Window Felt Weatherstrip Kit. Front doors only, inner and outer. Kit can also be cut to fit rear quarter area.

• Eldorado convertible

PART #10-039X
$97.50 / kit

Filler Strip, Sash Channel, for all applications fitting glass to sash channel not requiring weatherlip type of filler. Check your old filler strip to find thickness needed. This is the highest quality linen back, rubber cork composition for a professional job on swing out windshields, door vent windows and convertible side windows having metal frames, as well as many side or door windows on closed bodies. Please specify thickness required. This item is not returnable except for quality assurance issues. Order by the foot.

• Many models, as required

PART #10-041X (1/32" thick)
$1.10 / ft.

PART #10-042X (1/16" thick)
$1.10 / ft.

Filler Strip, Sash Channel. Constructed of a rubber-like polymer designed for setting glass in a metal sash channel. This item is not returnable except for quality assurance issues. Order by the foot.

• Many models, as required

PART #10-043X (1/32" thick)
$1.10 / ft.

PART #10-044X (1/16" thick)
$1.10 / ft.

Click to ENLARGE

Motor, Window Lift. Used for front or rear door window & rear quarter window. Factory rebuilt GM part# 5045639 & 5045640. ***Please note: motors are in stock, however this is an exchange item only - there will be a refundable core charge.***

• All models

PART #06-123X (driver side)
$74.50 ea.

PART #06-124X (passenger side)
$74.50 ea.

REFUNDABLE CORE CHARGE $25.00/motor

Convertible Roof Rail Weatherstrip. The roof rail is the section typically over the side and rear quarter windows when the top is up. The roof rail kit contains 5 pieces, including the front bow seal. The hinge pillar section is the weatherstrip typically between the windshield post and the front door opposite the vent window. The hinge pillar kit contains 2 pieces, pair, L & R. Roof rail & hinge pillar its are sold separately.

Hardtop Roof Rail Seals. The roof rail seals seal the tops of the windows to the body. Made with molded ends to factory specifications for an exact fit.

Weatherstrip, Front Bow to Windshield. Included in convertible roof rail kit #11-146R listed above. Replaces original GM part # 9833656 .

• Eldorado convertible

PART #13-003X
$49.00 ea.

Door Weatherstrip, pair left and right. High quality reproductions made with molded ends and clips as required. If you do not see your model listed in this section, please refer to our "Door Seals By the Foot" in the next section.

Weatherstrip, Door Edge. Use this seal if we do not have an exact match for your model in the "door weatherstrip kits" listed in the previous section. Great for ambulance, hearse, etc. For cement-on or nylon fastener applications. Available with or without molded in clips. Compare your original seal profile to the sketch. Sold by the foot.

PART #12-016X (without clips)
$3.90 / ft.

PART #12-017X (with clips)
$4.80 / ft.

Weatherstrip, Door Edge. Use this seal if we do not have an exact match for your model in the "door weatherstrip kits" listed in the previous section. Great for ambulance, hearse, etc. For cement-on or nylon fastener applications. Available with or without molded in clips. Compare your original seal profile to the sketch. Sold by the foot.

PART #12-014X (without clips)
$3.50 / ft.

PART #12-015X (with clips)
$4.90 / ft.

Door Lock Pillar Seals. These weatherstrip's are normally used to seal the bottom edge of a quarter or rear side window on the lock pillar of the body. These fillers will have a metal core if required for proper operation.

Bumper, Door Edge, twin retainer style. 13/16" long x 1/2 " tall x 3/8 " thick. We carry this type of bumper in many sizes. If you can't find the one you need please give us a call or visit our "Door Bumpers" page to view all available sizes.

• All models as required

PART #12-006B
$2.25 ea.

Bumper, Door Edge, twin retainer style. 15/16" long x 3/8" tall x 1/2" thick. We carry this type of bumper in many sizes. If you can't find the one you need please give us a call or visit our "Door Bumpers" page to view all available sizes.

• All models as required

PART #12-005B
$2.25 ea.

Gasket, Door & Trunk Lock Cylinder. Exact reproduction of original GM part #4587931. 7/8" I.D.

• All models

PART #12-009P
$1.10 ea.

Gasket, Door Handle. Replaces original GM part #9829900 & #9831512. Four piece kit for 2 handles.

• All models

PART #12-008P
$6.80 / kit

Weatherstrip, Deck Lid/Trunk. Excellent quality rubber sponge, more durable than original. 18' Strip.

• All models

PART #16-004T
$19.00 ea.

Trunk Liner, loose weave. Black with scattered white threads. 54" wide. Sold by the foot

• All models

PART #17-001X
$9.75 / ft.

Bumper, Glove Box Door. For 1/8" to 5/32" hole, 5/32" thick pad, 5/16" diameter.

• Many models, as required

PART #18-001B
$0.80 ea.

Bumper, Glove Box Door. For 1/8" to 5/32" hole, 1/4" thick pad, 5/16" diameter.

• Many models, as required

PART #18-002B
$0.80 ea.

Bumper, Bench Seat. Made with steel core like original. 1-1/2" long, 7/16" thick. 2-4 Required per vehicle. These bumpers can be seen when you push the front seat forward to access the rear seat.

• All 2 door models w/ bench seat

PART #18-006B
$5.00 ea.

Grommet, Sun Visor Rod. Made of gray rubber, 3/4" long.

• All models

PART #18-006X
$1.75 ea.

Trip Meter Reset Knob . UNIVERSAL type made of black rubber. 1/8" I.D., 7/16" O.D. X 1/2" tall.

• All models

PART #18-007X
$5.00 ea.

Grommet, Instrument Panel to Windshield Frame. 2-6 required. Replaces original GM part #4614412.

• All Fleetwood Sedan and Limo

PART #18-005G
$5.90 ea.

1/4-20 U-Nut. Used on most models for many applications.

• All models

PART #19-012F
$0.65 ea.

Clip, Multi-Purpose. Many applications. Identical to original GM clips.

• Many models

PART #19-011F
$0.35 ea.

Clip, Hood to Cowl Weatherstrip. Replaces original GM part #480534. Normal usage is 14 to 16 per car as needed. 3/4" tall with a 1"wide head.

• All models

PART #04-101F
$0.60 ea.

Clip, Multi-Purpose. Many applications. Identical to original GM clips.

• Many models

PART #19-003F
$0.85 ea.

3M™ Adhesive Remover. Quickly removes wax, grease, oil and adhesive residue. It will not harm most cured automotive paints and is also suitable for vinyl and glass surfaces. 8 oz. can.

PART #23-002X
$13.00 / 8 oz. can

3M™ Super Weatherstrip Adhesive (BLACK) is a strong, flexible, rubbery adhesive that can withstand vibration, oil, grease, and extreme temperature variations. It can be used to bond weatherstripping to car doors, trunks, T-tops, moon roofs and sun roofs. It is an excellent adhesive for holding paper, cork, or rubber gaskets in place during installation. It provides the strength and rapid setting needed to hold weatherstripping, headliners, and side panels in place. 5 oz. tube.

PART #23-003X
$11.00 / 5 oz. tube

3M™ Super Weatherstrip Adhesive (YELLOW) is a strong, flexible, rubbery adhesive that can withstand vibration, oil, grease, and extreme temperature variations. It can be used to bond weatherstripping to car doors, trunks, T-tops, moon roofs and sun roofs. It is an excellent adhesive for holding paper, cork, or rubber gaskets in place during installation. It provides the strength and rapid setting needed to hold weatherstripping, vinyl headliners, and side panels in place. 5 oz. tube.

PART #23-001X
$11.00 / 5 oz. tube